MK23 Pic Request

[MaD HuNGaRIaN]

Can someone take a couple shots of their Mark 23's trigger bar spring from the top looking down on the frame? I need to see how close it is in relation to the frame or trigger bar. If you can, take a shot of the end that hooks up to to the bar near the hammer end. Thanks in advance for anyone who can help.

[gemarsh]

I would say they touch... ooops...I should have not said that. Now someone will say working on the Mark23 is like putting a blower on a SBC. :>) Sure you don't need it, but it sure is fun to run.

http://webpages.charter.net/gemarsh/files/tmright.jpg

Be Safe
Gayle

[MaD HuNGaRIaN]

Thanks a million gemarsh, I appreciate you taking the time.

[ARKAY.357]

I would say they touch... ooops...I should have not said that. Now someone will say working on the Mark23 is like putting a blower on a SBC. :>) Sure you don't need it, but it sure is fun to run.

http://webpages.charter.net/gemarsh/files/tmright.jpg

Be Safe
Gayle



What is that next to the frame? It looks like a braided wire. I've never seen a Mark23 taken down before.

Thanks;

ARKAY

[MaD HuNGaRIaN]

That is the trigger bar spring that I was asking about. And, from this angle, I can't really tell what I needed to know. This one looks like it's touching the trigger bar, whereas mine is rubbing on the frame, and hence the underside of the slide.

[gemarsh]

The spring is inserted into the hole on the back end of the trigger bar. I'll post a pic of it when I get home. A little tweaking is needed to maintain clearance between frame and bar. It's a tight fit. But once you tweak it, it will miss both.

Be Safe
Gayle

[gemarsh]

Man, what a pain to photograph!

http://webpages.charter.net/gemarsh/files/Dsc00012.jpg

Be Safe
Gayle

[MaD HuNGaRIaN]

AWESOME, Thanks...100 percent what I needed to see. Do you find the it rides in and out at will? or did you do something to get it to stay in the center like that?