Interesting discussion on 9mm ejectors. It almost appears that the MP5k ejector was "activated" a little earlier by the bolt, possible due to the higher cycle rate of the MP5k. Anyone have additional information, would be interested in a side discussion (ideally engineering notes and a software model ... but general tidbits are more than enough ;-).
This brings another set of variables into play, and may in a tiny part explain why some have issues with certain setups and other do not.
Regards
John
I use the third generation version (got it from Adam) in my sear pack with my SW5, CA89 (both of them) and CA89K. It works perfectly in all of them. But I'm also using actual HK bolt assemblies in all these guns when using that ejector. In any case, I only change the ejector when I'm going to another caliber.
"Sometimes change sucks."- Anne Frank
I too was under the impression that the K and std ejectors were the same. Any chance of some pics of the different ones stacked up on each other?
It would sure help for some one to take pics of all the ejector levers, old and new sorted by caliber and made into a sticky.
I long for the days of stamped HKs.
+1Originally Posted by wh
Dave
Posting Permissions
Reply With Quote
