Well I sent my gun off to get the engraving done and then got the fake suppressor removed. I think I have a problem though, one of the lugs looks a little smaller than the other ones. I was going to buy a 3 lug suppressor but now am scared that it won't fit. If one of the lugs out of spec am I screwed. Should I buy a HK flashider first and try it? Is that the best thing to do.
Bigyellow
I found out my lugs were out of spec when I went to put my german flash hider on and they had to be taken down and refinished by my gun smith.
My barrel from www.rimcountrymfg.com has the 3 lugs that fit the flashider great. I guess if you are going to cover up your mistakes with a fake suppressor it really does'nt matter
Mine look the same ( I have 3 weapons from CA). I bought an HK flashhider and the damn thing would not go onto the CA89. After using some sandpaper on the 3 lug and tip it goes on great. I just got a Gemtech Raptor and it goes on with no problem. I venture to say, if you can get the flashhider to fit, your suppressor should not be an issue.
If thats your only problem consider yourself lucky.
Jayson at IGF could fix it and he does a nice refinish job.
Jayson at IGF could fix it and he does a nice refinish job.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
